Thermo Scientific Precision Water Bath User Manual page 39

Chapter 2 | General Information
2-2
| Precision
Coliform Bath Specifications
Reservoir Fluid Set Point
Temperatures °C
°F
Ambient Temperature °C
Range °F
Stability @ 37°C
Uniformity @ 37°C
Heating Output watts
Bath Volume liters
Overall Bath Dimensions
(L x W x H) cm
inches
Bath Work Area
Dimensions
(L x W x H) cm
inches
Approximate Weight kg
lb
Electrical
Requirements (VAC/Hz)
(Voltage ±10%)
Pump Pressure mbar
Pump Flow lpm
Compliance
Maximum Relative
Humidity
(Non Condensing)
Operating Altitude meters
feet
Overvoltage Category
Pollution Degree
Storage Temperature °C
Range °F
Reservoir fluid set point temperatures are fixed and cannot be changed.
Specifications obtained at sea level using water.
Bath depth includes bezel, height does not include lid.
Heater output measured at mains supply of 120 VAC and 240 VAC.
Thermo Fisher Scientific takes no responsibility for damages caused by the selection of an unapproved fluids.
Thermo Fisher Scientific reserves the right to change specifications without notice.
COL 19
35.0, 41.5, 44.5, 45.5
95.0, 106.7, 112.1, 113.9
+15 to 45
+59 to 113
±0.1
±0.05
1200
19
39.4 x 63.2 x 24.9
15.5 x 24.9 x 9.8
30.5 x 38.7 x 19.2
12.0 x 15.3 x 7.6
20
35
100-115/50-60
or
200-230/50-60
262
10.6
CE
UL
80% for temperatures up to 31°C (88°F)
decreasing linearly to 50% relative humidity at 40°C (104°F)
Sea Level to 2000
Sea Level to 6560
II
2
-25 to +60
-13 to +140
COL 35
1500
35
39.4 x 93.8 x 24.9
15.5 x 36.9 x 9.8
30.5 x 69.2 x 19.2
12.0 x 27.3 x 7.6
27
60
RoHS
WEEE
Thermo Scientific