Table of Contents
Advertisement
21 . Remove and discard mating ring and seal (Fig . 24 .1) .
22 . Carefully remove auger (Fig . 24 .2) .
WARNING!
Use caution when removing auger. The auger is very
sharp - handle with care to avoid personal injury.
Evaporator Assembly
1 . Remove and inspect main housing O-ring seal . Replace if
damaged in any way .
2 . Clean O-ring groove . Lubricate O-ring with Petrol-gel and
reinstall .
3 . Use cardboard disc to press new mating ring into main
housing (Fig . 25 .1) .
4 . Lube the shaft with liquid soap in the area shown
(Fig . 25 .2) and slip on seal and spring (Fig . 25 .3) .
Note: Do not touch the sealing surfaces with bare hands .
Contact with bare skin will cause premature seal failure .
5 . Install auger (Fig . 25 .4) .
6 . Install main housing:
§ Slide main housing onto auger shaft (Fig . 26 .1) .
§ Install three M6x25 allen screws (Fig . 26 .2) .
§ Connect vent line to T fitting (Fig . 26 .3) .
Sparkling Water and Ice Dispenser 7CI100A/7FS100A, 15CI100A/15FS100A
Fig . 24
1
Fig . 25
1
Cardboard
disc
Do NOT
touch!
2
3
Fig . 26
3
2
2
4
1
27
Advertisement
Table of Contents
