Service
(continued) –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
21. Remove and discard mating ring and seal (Fig. 18.1).
22. Carefully remove auger (Fig. 18.2).
WARNING!
Use caution when removing auger. The auger is very
sharp - handle with care to avoid personal injury.
Evaporator Assembly
1. Remove and inspect main housing O-ring seal.
Replace if damaged in any way.
2. Clean O-ring groove. Lubricate O-ring with Petro-gel
and reinstall.
3. Use cardboard disc to press new mating ring into
main housing (Fig. 19.1).
4. Lube the shaft with liquid soap in the area shown
(Fig. 19.2) and slip on seal and spring (Fig. 19.3).
Note: Do not touch the sealing surfaces with bare hands.
Contact with bare skin will cause premature seal
failure.
5. Install auger (Fig. 19.4).
6. Install main housing:
§ Slide main housing onto auger shaft (Fig. 20.1).
§ Install three M6x25 allen screws (Fig. 20.1).
§ Connect vent line to T fi tting (Fig. 20.1).
16
Undercounter Dispenser and Ice machine E7UC100A/E7UD100A
Fig. 18
1
Fig. 19
1
Cardboard
disc
Do NOT
touch!
2
3
Fig. 20
2
2
4
3
1