Optional Leg Accessory Installation
CAUTION!
Use caution when tipping the dispenser during leg installation. Do
not lay unit on back or side. DO NOT EXCEED 30° angle. Tipping
more than 30° can result in compressor malfunction.
1 . If installing optional 4" Leg Accessory (item# 00956300), place a
5" (12 .7 cm) spacer underneath the dispenser to ease installation .
2 . Remove four plastic, thread-protecting plugs from bottom of
dispenser .
3 . Screw each leg into chassis (Fig . 4) .
Freestanding Installation
Installation instructions for countertop model may be found on
Installation on page
10.
1 . A clearance of at least 3" (7 .62 cm) is required behind and on
each side of the dispenser for electrical connection and ventilation
(Fig . 5) .
2 . Rough-in the electrical service and water line(s) .
§ Electrical: 115V, single phase, 15A receptacle required . The dispenser
has an integral 8 ft (2 .4 m) cord and plug . The chiller/carbonator
connects to the dispenser via a supplied power cord .
§ Water: supply line (with shut-off valve) connects to 1/4" push-to-
connect Tee that splits the supply to the dispenser and chiller/
carbonator (also 1/4" push-to-connect) .
12
Sparkling Water and Ice Dispenser 7CI100A/7FS100A, 15CI100A/15FS100A
Fig . 4
5" (12.7 cm)
min.
Fig . 5
Countertop
spacer
freestanding models
minimum 3" (7.62 cm)
clearance required