Attach Optional Mid-Level Spreader - Vinten V4160-0001 User Manual

Attach Optional Mid-Level Spreader

CAUTION! Ensure the latching pins are fully engaged with
!
the locating holes in the tripod. Failure to attach correctly
could result in damage to the equipment
The tripod is delivered with the Hinge Lock in the OFF
position for use with a spreader.
(See page 14 for lock operation).
1.
Hold the spreader between thumb
and forefinger and squeeze the
release buttons on each side.
2.
Align the latching pins with the locating
holes on the tripod leg.
3.
Release the buttons to lock the
spreader in place.
4.
Unlock the spreader arms to allow the arms to extend as required.
5.
Tighten the spreader locks when the tripod legs are in the correct
position.
If the spreader will not lay flat when fitted, check the Hinge
Lock is in the OFF (spreader mode) position for use with a
spreader. (See page 14 for lock operation).
Cleaning.
After each use, brush off any dirt or debris, if necessary wash down
with clean water.
Installation Installation
7