Fantasea Line FRX100 VI Instruction Manual page 13

d. Open the housing (see section "Opening the Housing" on the following page) and remove
the anti-glare hood out of the housing. Secure the anti-glare hood to the housing by tying
its secure string around the lower rectangular loop at the bottom left side of the housing.
Install the anti-glare hood over the anti-glare hood rails at the back of the housing. First
install the anti-glare hood over the top rail (image #3 on the following page) and then
gently and carefully stretch it downwards to install it on the bottom rail, making sure it's
sitting securely on both upper and lower rails (image #4 on the following page).
e. If using a Hand Strap, install it on the two loops found at the right side of the housing.
Please refer to the section "Hand Strap" for further information.
f. It is important that a first dive with the housing is always made without the camera in
order to verify that the housing watertight seal has not been affected during transport
and after long periods of storage.
13
Image #1
FRX100 VI Housing Limited Edition - Instruction Manual 20181003
Image #2