Table of Contents
Advertisement
4. It is best to set the camera flash mode to "Flash
Always" as artificial light is required in most
compositions for the purpose of color and light
reproduction. This will ensure the built-in camera
flash fires on every image taken regardless of
ambient light available. Please refer to the
camera instruction manual for further
instructions regarding such settings.
5. Turn the Flash Pop-Up dial counterclockwise in
order to pop up the camera built-in flash.
6. Note that once the camera built-in flash has
been popped up, it can be disabled again using the Flash / Right control and selecting "flash
disabled" on the flash mode menu. Turning the Flash Pop-Up control clockwise will not have any
effect on the built-in flash.
When shooting in M (Manual), A (Aperture priority) or S (Shutter Speed priority) shooting modes,
please take into consideration that once the flash has been popped up – it cannot be disabled.
Therefore, in such cases, it's recommended to switch to Auto shooting mode to eliminate the flash
after it has been popped up.
OPTIONAL ACCESSORIES
FOR THE FULL SELECTION OF FANTASEA ACCESSORIES COMPATIBLE WITH THE FRX100 VI HOUSING LIMITED EDITION,
PLEASE REFER TO THE FANTASEA WEBSITE –
EXTERNAL FLASHES
Underwater flashes and strobes were designed to improve the color, lighting and quality of your
underwater images. Since light and color are absorbed by water, using an external flash is recommended in
all depths, during daylight and night dives. In addition to retrieving the color and light absorbed by water,
underwater flashes also allow for creative lighting, assist in reducing the amount of backscatter and prevent
the shadowing effect caused by the housing lens port when using the built-in camera flash, especially when
accessory lenses are mounted on the housing.
The FRX100 VI Housing Limited Edition can be used with underwater slave flashes. These external flashes
feature a slave sensor which triggers the external flash to fire in sync with the internal camera flash.
Most underwater slave strobes are capable of synchronizing with the internal camera flash without any
cables under certain diving conditions. They feature a slave sensor that triggers the strobe to fire in sync
with the camera built-in flash as long as the strobe and the camera are positioned on the same axis and as
20
WWW.FANTASEA.COM
FRX100 VI Housing Limited Edition - Instruction Manual 20181003
Image #16
Advertisement
Table of Contents
