Fantasea Line FRX100 VI Instruction Manual page 24

2. Place the wide flat Velcro mid-section over the
locking latch and pull the thin Velcro strip over the
top of this mid-section and through the upper
housing ring from bottom to top all the way through
(image #23).
3. Double back the thin nylon Velcro strip and secure it
tight to the top of the Velcro strip previously
inserted (same strip) and press down. Then cover
with the wide flap (should be on the right side) over
the thin Velcro strips (image #24).
4. Place top flap (with logo) over bottom flap and press to close (image #25).
5. To use, slide right hand from back side to front of the
Hand Strap with knuckles protruding slightly out of the
front (lens side) of the strap (image #26). Have it snug
but not too tight, to allow for control manipulation.
6. Always use the wrist lanyard with the hand strap.
7. When opening or closing the housing, you may need to
loosen the Hand Strap slightly in order to rotate it
forward to allow for easier opening and closing of the
latch.
8. When closing the housing, take special notice and care
not to close part of the Hand Strap inside the housing,
which will interfere with the watertight seal of the housing.
9. Make sure to rinse the Hand Strap in fresh water and then dry after every use. Store in a dry, shaded
area.
24
Image #24
FRX100 VI Housing Limited Edition - Instruction Manual 20181003
Image #23
Image #25
Image #26