Removing The Camera From The Housing - Fantasea Line FRX100 VI Instruction Manual

5. Gently try pulling the back door away from the front door. If the housing is properly closed, it should
be impossible to open the back door.
6. Visually inspect the black O-ring through the transparent back door for proper closure. Make
sure it isn't twisted or out of the groove and that no foreign matter has been caught in the seal,
such as secure lines, sand, grit, hairs or any other foreign substance.
7. Turn the camera on and check that the extended camera lens does not catch or bend the black
rubber seat on the inside of the lens port. It is vital that this rubber seat does not disturb the
lens.
8. Test housing control buttons to make sure that the camera was properly installed inside the
housing and that nothing interferes with normal operation of the camera. It is recommended to
take a few images once the camera has been installed inside the housing and prior to the dive in
order to ensure proper operation.
9. If making use of the internal camera flash, install the removable flash diffuser on the housing
and attach the flash diffuser quick release secure string in order to avoid losing it underwater.
10. Prior to diving with the housing, submerge it in a shallow tub of water or rinse tank. Carefully look at
the housing to make sure no bubbles are escaping from it and that no water is entering.

REMOVING THE CAMERA FROM THE HOUSING

1. After use, thoroughly rinse the housing fresh water. Prior to opening the housing, make sure
both your hands and the housing are clean and dry. It is recommended to have a clean, dry and
soft towel handy in order to dry your hands and the water drops on the housing.
2. When opening the housing, it is important to hold it so the lens port is facing down. This will
prevent the camera from slipping out of the housing while being opened.
18
Image #12
FRX100 VI Housing Limited Edition - Instruction Manual 20181003
Image #13