KYMCO FILLY LX 50 Service Manual page 48

4
. LUBRICATION SYSTEM
ENGINE OIL/OIL FILTER
OIL LEVEL
• Place the motorcycle upright on level
ground for engine oil level check.
• Run the engine for 2 3 minutes and
check the oil level after the engine is
stopped for 2 3 minutes.
Remove the oil dipstick and check the oil
level with the oil dipstick.
If the level is near the lower level, fill to the
upper level with the specified engine oil.
OIL CHANGE
The engine oil will drain more easily
while the engine is warm.
Remove the drain bolt to drain the engine oil
thoroughly.
Remove the oil filter screen cap and clean the
oil filter screen with compressed air.
Check the filter screen O-ring for damage and
replace if necessary.
Install the oil filter screen, spring and filter
screen cap.
Torque: 1.0~2.0kgf-m
Fill the crankcase with the specified engine
oil to the proper level.
Oil Capacity: At disassembly : 0.85 liter
At change
Check for oil leaks and then start the engine
and let it idle for few minutes.
Recheck the oil level.
: 0.70 liter
Oil Dipstick
Oil Filter Screen Cap
O-ring
FILLY LX 50
4-2