KYMCO FILLY LX 50 Service Manual page 139

12
. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
Remove the piston from the brake caliper.
If necessary, use compressed air to squeeze
out the piston through the brake fluid inlet
opening and place a shop towel under the
caliper to avoid contamination caused by the
removed piston.
Check the piston cylinder for scratch or wear
and replace if necessary.
Push the piston oil seal outward to remove it.
Clean the oil seal groove with brake fluid.
Be careful not to damage the piston
surface.
Brake Caliper Seat
Compressed Air
Piston Oil Seal
Place the brake master cylinder on the
handlebar and install the holder with "up"
mark facing up. Be sure to align the punch
mark with the holder joint.
First tighten the upper bolt and then tighten
FILLY LX 50
12-14