Advertisement
Format
After outputting the command for acquiring FLOWDATA, the binary data is output in the
following format:
Header division (4bytes)
Configuration of FLOWDATA p.17
Binary data is used for response data of FLOWDATA to give the highest priority to the speed. Therefore,
general purpose communication tools such as HyperTerminal may not be used to receive the data.
■ Buffer size and buffer intervals
The buffer size of measurement data to be accumulated in the ZS controller and its buf-
fer intervals can be changed.
Change the following parameters:
* DATAGET and DATASET commands are used to change and refer to the parameters.
Unit No.
Data No.
124
2
3
4
■ Logging data
Data to be accumulated in the ZS controller can be selected.
• When multi-task mode is OFF
• When GLASS/MODE 2 or GLASS THICKNESSS/MODE 2 is selected for the mea-
surement object
Unit No.
Data No.
124
5
• When a mode other than the above is selected for the measurement object
Unit No.
Data No.
124
5
Data division (4bytes)
Parameter
FLOWDATA accumulation
mode
Buffer intervals
Buffer size
Value
0
1
2
3
Value
0
1
Non-procedural Communication Command Reference
FLOWDATA Reference
Description
0: OFF
1: ON
1 to 65535 (pcs)
1 to 1000 (pcs)
Description
No accumulation
Accumulation of result of area 1
Accumulation of result of area 2
Accumulation of result of glass surface or
glass thickness
Description
No accumulation
Accumulation
ZS-HL-N Series
15
Advertisement
