Installing Sip Phones At A Remote Site - Panasonic KX-NS300 Installation Manual

Hybrid ip-pbx
Hide thumbs Also See for KX-NS300:
Table of Contents

Advertisement

5.8.3 Installing SIP Phones at a Remote Site

5.8.3 Installing SIP Phones at a Remote Site
If an SBC (Session Border Controller) is present on the same local network as the KX-NS300, you can install
SIP phones at remote sites without needing to configure special network settings (NAT traversal, etc.).
This section provides information about the procedure for connecting SIP Phones at a remote site that has
SBC hardware.
When SIP phones in remote sites use the internet to communicate with the PBXs, use the HTTPS protocol for
security. If the connection is within a VPN and protected, you may use the HTTP protocol.
1
Main Unit*
IP-PT
Main Site (Headquarters)
: RTP packets
*1
KX-NS300
Note
Install the SBC in the same LAN as the KX-NS300.
A KX-NS300 can work with only one SBC. Also, multiple sites can share an SBC.
A KX-NS300 can support up to 20 remote extensions at the same time via SBC when using the HTTPS
protocol.
All the RTP packets in between the main site and the remote site is routed to the SBC for security and
for IP address conversion.
When settings of remote extensions being used at remote sites are changed at the KX-NS300 at the
main site, the reflection of the changes to the remote extension may require some time due to data
transfer protocols.
Programming the KX-NS300
Follow the procedures below to configure remote port settings using Web Maintenance Console.
Note
For the procedures below, program WAN side IP information of the router at the main site.
This information is sent to KX-UT series SIP phones at the remote site after completing all programming.
For Site Property Settings
1.
Click Setup ® PBX Configuration ® Configuration ® Slot.
2.
Move the mouse pointer over System Property.
A menu will be shown under the mouse pointer.
3.
Click Site.
4.
Click the SIP Extension tab.
5.
Click Advanced Setting for Remote SIP-MLT.
Program the WAN side IP information in Setting parameters assigned to Remote SIP-MLT.
226
Installation Manual
Switching Hub
Router
SBC
Internet
Router
Switching Hub
KX-UT series
SIP phone
Remote Site

Advertisement

Table of Contents
loading

Table of Contents