Table of Contents
Advertisement
Assignment of the terminal block
The supplied connecting cable has the following assignment:
Contact
1
2
3
4
5
6
7
8
9
Note
Pin assignment of the RJ-11 jack on the device
The RJ-11 jack on the device has a pinout to match the RJ-11 plug of the supplied
connecting cable.
6.6
Out-of-band interface
Information on the out-of-band interface
● The out-of-band interface is an RJ-45 Ethernet port on the CPU module. The out-of-band
interface is not used for routing or switching.
● Access to the device is also possible independent of the other Ethernet ports.
● The out-of-band interface allows direct IP access to the WBM of the device.
IP address of the out-of-band interface
The IP address of the out-of-band interface cannot be configured with the Primary Setup
Tool (PST). You have two options for address assignment:
● Configuration over a serial interface and the Command Line Interface.
● Access over an in-band port that already has an IP address. Configuration over WBM
(menu command "Layer 3" > "Subnets" > "Configuration" tab) or the Command Line
Interface.
SCALANCE XR-500
Operating Instructions, 09/2018, A5E03275845-12
Pin assignment of the RJ-11 plug
-
-
TD (Transmit Data)
SG (Signal Ground)
RD (Receive Data)
-
6.6 Out-of-band interface
Pin assignment of the D-sub female con-
nector
-
TD (Transmit Data)
RD (Receive Data)
-
SG (Signal Ground)
-
-
-
-
Connecting
73
Advertisement
Table of Contents
