Endress+Hauser Flowmeter Proline 200 Brief Operating Instructions page 31

Flowmeter Proline 200
6.3.1 Operational display
Explanatory symbols for the measured value
• Depends on the device version, e.g.:
– : Volume flow
– : Mass flow
– : Density
– G: Conductivity
– : Temperature
• : Totalizer
• : Output
• : Input
• : Measurement channel number
2)
• Diagnostic behavior
– : Alarm
– : Warning
1) If there is more than one channel for the same measured variable type (totalizer, output etc.).
2) For a diagnostic event that concerns the displayed measured variable.
6.3.2 Navigation view
Status area
The following appears in the status area of the navigation
view in the top right corner:
• In the submenu
– The direct access code for the parameter you are
navigating to (e.g. 0022-1)
– If a diagnostic event is present, the diagnostic
behavior and status signal
• In the wizard
If a diagnostic event is present, the diagnostic behavior
and status signal
6.3.3 Editing view
Text editor
Confirms selection.
Exits the input without applying the changes.
Clears all entered characters.
Switches to the selection of the correction tools.
Toggle
Aa1
• Between upper-case and lower-case letters
• For entering numbers
• For entering special characters
Endress+Hauser
Status area
The following symbols appear in the status area of the
operational display at the top right:
• Status signals
– F: Failure
– C: Function check
– S: Out of specification
– M: Maintenance required
• Diagnostic behavior
–
1)
–
• : Locking (locked via hardware))
• : Communication via remote operation is active.
Display area
• Icons for menus
– : Operation
– : Setup
– : Diagnostics
– : Expert
• ▸: Submenus
• : Wizards
• : Parameters within a wizard
• : Parameter locked
Correction symbols under
: Alarm
: Warning
Clears all entered characters.
Moves the input position one position to the
right.
Moves the input position one position to the left.
Deletes one character immediately to the left of
the input position.
Operation options
31