Cleaning The Hot Tub Interior; Pillow Care - Sundance Spas 880 Series Owner's Manual

880 Export Series
3. Locate the Quick Drain Valve. Unscrew
drain valve cap (Figure C). Place the cap
aside.
4. Screw in the adapter with hose that
was included in the equipment bay,
attached to the quick drain (Figure D).
Make sure to direct the hose to an area
where the water will drain properly.
5. Open the drain slice valve by sliding the handle to the side
and pulling up.
6. After the hot tub has drained close the slice valve by pushing it
downward and sliding the handle to the side. Remove the adapter
and reinstall the Quick drain cap before refilling hot tub.
13.4

Cleaning The Hot Tub Interior

To preserve the sheen of your hot tub's surface, it is crucial that you
avoid using abrasive cleaners or cleaners which have adverse chemical
effect on the surface. If you are not certain as to the suitability of a
particular cleanser, consult your authorized Sundance Spas dealer.
Regardless of the cleanser used, use extreme care to assure that no
soap residue is left on the surface. This could cause severe sudsing
when the hot tub is refilled.
13.5

Pillow Care

Remove and clean the headrest pillows as needed with
soapy water using a cloth or soft-bristle brush. Always
remove the pillows when adding chemical shock treatment
to the spa water. The pillows can be returned to the spa when the
sanitizer reading is stable as recommended on the inside cover of the
manual.
Note: Pillow can vary from one shown.
1
Place both hands on
pillow with thumbs as
shown.
Wash pillow(s) in a mild detergent soap and warm water solution. Never machine wash your pillows
5
or attempt to clean them with a cleaning agent!
To reinstall pillows: Simply align pillow over mounting stud receptacle, then gently push inward to
6
snap in place.
50
2
Press inward with
thumbs to curl pillow
lip inward so you can
grab it with fingertips.
Figure C
3
Flex pillow lip inward
2-3" to get a good
grip on the ends.
Figure D
4
Gently pull outward on
pillow to release mounting
stud from receptacle on
spa shell.