Cleaning The Hot Tub Interior; Pillow Care - Sundance Spas MARIN 880 Series Owner's Manual

B. Draining Procedures (Quick Drain):
1. Turn off power to hot tub at the breaker.
2. Remove the front panel, see page 71 for
instructions.
3. Locate the Quick Drain Valve (Figure C).
Unscrew drain valve cap (Figure D). Place the
cap aside.
4. Screw in the adapter with hose that was included
in the equipment bay, attach it to the quick drain
(Figure E). Make sure to direct the hose to an
area where the water will drain properly.
5. Open the drain slice valve by sliding the handle
to the side and pulling up.
6. After the hot tub has drained close the slice valve by
pushing it downward and sliding the handle to the side.
Remove the adapter and reinstall the Quick drain cap
before refilling hot tub.
13.4

Cleaning The Hot Tub Interior

To preserve the sheen of your hot tub's surface, it is crucial that you avoid
using abrasive cleaners or cleaners which have adverse chemical effect
on the surface. If you are not certain as to the suitability of a particular
cleanser, consult your authorized Sundance Spas dealer. Regardless of
the cleanser used, use extreme care to assure that no soap residue is
left on the surface. This could cause severe sudsing when the hot tub is
refilled.
13.5

Pillow Care

Remove and clean the headrest pillows as needed with
soapy water using a cloth or soft-bristle brush. Always
remove the pillows when adding chemical shock treatment to
the spa water. The pillows can be returned to the spa when the sanitizer
reading is stable as recommended on the inside cover of the manual.
Note: Actual pillow could vary from image shown.
1
Place both hands on
pillow with thumbs as
shown.
Wash pillow(s) in a mild detergent soap and warm water solution. Never machine wash your pillows
5
or attempt to clean them with a cleaning agent!
To reinstall pillows: Simply align pillow over mounting stud receptacle, then gently push inward to
6
snap in place.
2
Press inward with
thumbs to curl pillow
lip inward so you can
grab it with fingertips.
3
Flex pillow lip inward
2-3" to get a good
grip on the ends.
880 Series
102 °
Figure C
Figure D
Figure E
4
Gently pull outward on
pillow to release mounting
stud from receptacle on
spa shell.
73