Cleaning The Hot Tub Interior; Pillow Care - Sundance Spas Maxxus Owner's Manual

880 SERIES
Draining Procedures (Quick Drain):
1. Turn off power to hot tub at the breaker.
2. Locate the two Quick Release Door buttons
for the center cabinet, (Figure A). Press the
buttons to release the panel from the spa
frame. Gently pull the cabinet forward and
off (Figure B). Place the panel in a safe
location to prevent from damaging it.
Note: For the Maxxus and Aspen models the
front panel must be unscrewed to be removed.
3. Locate the Quick Drain Valve. Unscrew
drain valve cap (Figure C). Place the cap
aside.
4. Screw in the adapter with hose that was
included in the equipment bay, attach it to
the quick drain (Figure D). Make sure to
direct the hose to an area where the water
will drain properly.
5. Open the drain slice valve by sliding the
handle to the side and pulling up.
6. After the hot tub has drained close the slice valve by pushing it
downward and sliding the handle to the side. Remove the adapter
and reinstall the Quick drain cap before refilling hot tub.
13.4

Cleaning The Hot Tub Interior

To preserve the sheen of your hot tub's surface, it is crucial that you
avoid using abrasive cleaners or cleaners which have adverse chemical
effect on the surface. If you are not certain as to the suitability of a
particular cleanser, consult your authorized Sundance Spas dealer.
Regardless of the cleanser used, use extreme care to assure that no
soap residue is left on the surface. This could cause severe sudsing
when the hot tub is refilled.
13.5

Pillow Care

Remove and clean the headrest pillows as needed with
soapy water using a cloth or soft-bristle brush. Always
remove the pillows when adding chemical shock treatment
to the spa water. The pillows can be returned to the spa when the
sanitizer reading is stable as recommended on the inside cover of the
manual.
Page 70
102 °
SENTRY
SPA CONTROLLER
Figure A
102 °
Figure B
Figure C
Figure D