Sundance Spas 880 Series Owner's Manual page 18

880 Export Series
7. For Australia/New Zealand, the spa should be supplied through
a residual current device (RCD) with a rated tripping current not
exceeding 30mA (IEC 60335-2-60).
8. Connect wires, color to color, on terminal blocks TB1 and TB3
(Figure C). TIGHTEN SECURELY! All wires must be hooked up
securely or damage could result.
9. Install control box door and reinstall the cabinet panel(s).
10. The electrical supply for this product must include a suitably rated
isolating switch and circuit breaker to comply with local electrical
regulations. This RCD/GFCI circuit breaker must be installed at the
power supply in the house electrical box.
IMPORTANT NOTICE :
!
spacers from the circulation pump prior to operation. Failure
to do so may result in loud pump noise. Store the bolts and
spacers in a safe location. Reinstall them if you move, tilt or
ship the hot tub.
Figure A (Equipment Area for Maxxus/Aspen Models)
6
2
9
Note: Equipment location (such as pumps, CLEARRAY®
system, drain, heater etc.) varies by model.
1. Control Box
2. Power Supply Entrance(s)
3. Jets Pump
4. Jets Pump
5. Jets Pump
6. Blower
7. Heater
8. Hot Tub Drain (Removable Exter-
nal Drain Cap)
9. Pump Drain Plug(s)
14
102 °
15
1
11
DANGER!
TURN POWER
OFF! DO NOT
LOOK AT LIT BULB.
SEVERE EYE
DAMAGE OR BLINDNESS
CAN OCCUR!
3
Power Lamp
on on
13
10. Filter/Circulation Pump
11. CLEARRAY® (Ultraviolet) Water
12. Control Panel
13. Quick Drain
14. SunSmart™ 2.0 Wi-Fi (Optional)
15. BLUEWAVE® 2.0 Wireless Audio
Remove the shipping bolts and
12
7
4
10
5
Purification System
System (Optional)
14
2
8