Post Install Setup / Lcd Screen - Wilson Electronics PRO Series Installation Manual

Post Install Setup
The Pro Series booster is designed with advanced internal programming which allows
it to automatically adjust itself for a variety of conditions and still boost weak signals .
After completing the amplifier installation, the LCD display and push button on the
lower panel of the Pro Series booster is used to verify the final gain that the booster
adjusted itself to produce after antennas have been placed . The display can also be
used (if necessary) to re-adjust antennas so the booster can produce maximum gain
and therefore, coverage . The LCD screen will show status for each band and inform
the installer if any bands may have had their gain reduced by the booster's internal
programming . In addition, an indicator light on the booster"s upper panel will help
diagnose the overall status of the booster by glowing in different colors . This will be
covered in the following page .
Understanding the LCD Screen
1 . Four bands can be individually selected:
The 700 MHz LTE Bands (B12/17 and B13) A700
AOK
The 1900 MHz 1700/2100 MHz
The 800 MHz Band
– PCS Band – AWS Band
– Cell Band
APCS AAWS
A800
AOK AOK
AOK
The single "BAND SELECT" button is used to scroll the display through the four
cellular bands in order to verify that each band is functioning properly . An asterisk
(located next to the band selected) will flash if one or more bands have been turned
down/off by the boosters control circuitry due to strong nearby cell site signal overload
("OVL") and/or oscillation detection ("OSC") from antennas being too close . This is
no cause for concern if the power light remains green and you are satisfied with your
indoor coverage area .
9
Contact Wilson Electronics Customer Support Team with any questions at 866-839-9361
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.