Placards And Decals - Snorkel S2255RT Operator's Manual

Chapter 7 – Prestart Inspection
Note
There is not an off switch for the fl ashing light.

Placards and Decals

To inspect the placards and decals:
1. Inspect all safety and operational placards and
decals. Make certain they are in place, in good
condition, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be
seen.
Caution
Solvents may contain hazardous ingredients. Fol-
low the manufacturer's label for proper use and
disposal. Wear protective gloves and splash-proof
safety glasses when using solvents.
3. Remove wet paint overspray with a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing, damaged, or illegible placards
or decals before operating the aerial platform.
Placard and decal kits are available from Snorkel.
Safety related placards and decals are illustrated on the
following pages. Refer to the appropriate decal page in
the machine parts manual for specifi c operational and
safety placards and decals.
34 S2255RT S2755RT - 15286-1