Chapter 9 - Stowing And Transporting; Stowing; Transporting; Lifting With A Forklift - Snorkel S2255RT Operator's Manual

To prevent unauthorized use and damage, properly
stow the aerial platform at the end of each work day. It
must also be properly stowed while transporting.

Stowing

Use the following procedure to properly stow the aerial
platform.
Caution
The extension deck is free to move when the exten-
sion handle locks are disengaged. Personal injury
may result from accidentally extending or retracting
the deck. Make certain both extension handle locks
are fully engaged when the deck is extended in the
working position and when it is stowed. Do not
attempt to extend or retract the platform unless the
aerial platform is on a level surface.
1. Fully retract the platform extension deck and ensure
that it is secured in position, with the latch handles
fully lowered and the locks fully engaged.
2. Fully lower the platform.
3. Push the emergency stop button inward on the
lower control panel.
4. Turn the battery disconnect switch off and lock it.
5. Securely close the cabinet doors.

Transporting

The aerial platform may be moved on a transport ve-
hicle. Depending on the particular situation, the aerial
platform may be lifted with a forklift, driven, winched, or
hoisted onto a vehicle such as a truck or trailer. Lifting
with a forklift is the preferred method.
The equipment used to load, unload, and transport the
aerial platform must have adequate capacity. The empty
vehicle weight is listed in Chapter 2 and is stamped on
the serial number placard.
The user assumes all responsibility for:
Ÿ Choosing the proper method of transportation.
Ÿ Choosing the proper selection and use of transpor-
tation and tie-down devices.
Ÿ Making sure the equipment used is capable of sup-
porting the weight of the aerial platform.
Ÿ Making sure all manufacturer's instructions and
warnings, regulations and safety rules of their em-
ployer, the DOT, and/or any other state or federal
law are followed.

Lifting With a Forklift

Use the following procedure to lift the aerial platform
with a forklift.
1. Properly stow the aerial platform.
2. Remove all personnel, tools, materials, or other
loose objects from the platform.
S2255RT S2755RT - 15286-1
Chapter 9 – Stowing and Transporting
3. Insert the forklift forks into the pockets at either side
of the machine (refer to Figure 9.1).
Figure 9.1 – Forklift Pockets
4. Do not raise the aerial platform higher than nec-
essary to transport it. Drive the forklift slowly and
carefully when transporting the aerial platform.

Winching

Use a winch to load and unload the aerial platform on
ramps that exceed the machine gradeability specifi -
cation. A winch may also be used when poor traction,
uneven surfaces, or stepped ramp transition make
driving hazardous.
Use the following procedure to winch the aerial platform
onto the transport vehicle.
1. Locate the transport vehicle so the aerial platform
will not roll forward after it is loaded.
2. Remove any unnecessary tools, materials, or other
loose objects from the platform.
3. Drive the machine to the foot of the loading ramp
with the front wheels nearest the ramp. Make sure
the machine is centered with the ramps and that
the steering wheels are straight.
4. Attach the winch to the tie-down lugs (refer to Fig-
ure 9.2) on the front of the chassis by looping the
chain or cable through the hole in the chassis and
back out in between the chassis and the front axle.
Figure 9.2 – Front Tie-Down/Lifting Lugs
47