Alignment Tapes; Output Level And Impedance - Sony DCR-TRV7 Service Manual

3-1-5. Alignment Tapes

Use the alignment tapes shown in the following table.
Use tapes specified in the signal column of each adjustment.
Name
Tracking standard (XH2-1)
SW/OL standard (XH2-3)
Audio operation check
(XH5-3 (NTSC), XH5-3P (PAL))
System operation check
(XH5-5 (NTSC), XH5-5P (PAL))
BIST check
(XH5-6 (NTSC), XH5-6P (PAL))
Table 5-3-2.
Fig. 5-3-3. shows the 75% color bar signals recorded on the alignment
tape for Audio Operation Check.
Note: Measure with video terminal (Terminated at 75 Ω)
For NTSC model
White (75%)
0.714V
1V
0.286V
Horizontal sync signal
Color bar signal waveform
For PAL model
White (100%)
0.7V
1V
0.3V
Horizontal sync signal
Color bar signal waveform

3-1-6. Output Level and Impedance

Video output
Special stereo mini jack
Output signal: 1 Vp-p, 75 Ω unbalanced, sync negative
S video output
4-pin mini DIN
Luminance signal: 1 Vp-p, 75 Ω unbalanced, sync negative
Use
Tape path adjustment
Switching position adjustment
Audio system adjustment
Operation check
BIST check
White (100%)
Burst signal
Q
I
Burst signal
Fig. 5-3-3. Color Bar Signal of Alignment Tapes
(75%)
0.286V
Color bar patten
0.3V
(100%)
Color bar patten
Chrominance signal: 0.286 Vp-p, 75 Ω unbalanced (NTSC)
Audio output
Special stereo mini jack
Output level: 327 mV (at load impedance 47 kΩ)
Output impedance: Below 2.2 kΩ
5–37
White
Q I Black
100%
: 0.300 Vp-p, 75 Ω unbalanced (PAL)