Gendex AcuCam Concept IV FWT User Manual page 31

032-0161-EN Rev 5
The Holster can be attached to the
Docking Station chassis either on the left
or on the right, connecting the opposite
bracket in the desired position.
NOTE: When mounting the holster on a
cabinet or attaching it to a dental
chair delivery unit, the bracket
(bar) is not necessary, and it can
be removed releasing the two
screws shown here. Store the
bracket for future use.
The Holster Back-Plate
comes with a "hook"
designed for connecting
the Holster to the delivery
unit of a common dental
chair. The two embedded
screws allow fixing the
holster in a stable
position.
NOTE: To align the camera
handpiece to the
others devices on the delivery unit, you may want to FLIP VERTICALLY
the holster backplate. The back plate is attached to the holster by
means of two screws located INSIDE the holster.
To operate correctly, the holster must be wired to the Docking Station through
its cable. Two cable lengths are available, for attaching the holster to the
Docking Station or for positioning the holster far away (i.e. on the Delivery
Unit, chair side). If the cable is not connected, both the holster button and the
LEDs will not work. The cable connector is hidden INSIDE the holster. To
replace the cable, it is necessary to open the holster.
To open the holster
NOTE: Do NOT try to open the holster while it's mounted on the delivery unit
and do not use the Concept IV handpiece or any other tool as a lever.
Where necessary, un-mount the holster first, by releasing the two
embedded screws.
Holster Bar and bracket
Back-Plate
Installation
3-9