Gendex AcuCam Concept IV FWT User Manual page 12

AcuCam® Concept® IV FWT User Manual
All the connectors but the handpiece are situated in the backside of the Docking
Station.
Connection Type (*)
S-Video IN (S-Video)
Holster (8-Pin mini-DIN)
S-Video Out (S-Video)
Foot Switch (8-Pin mini-DIN)
IEEE1394a (FireWire)
Power Supply
(*) In this order: from upper left to lower right.
1-6
Purpose
S-video signal input for alternative analog video sources.
Holster connection for controlling the handpiece
activation.
S-video signal output for analog monitor.
Foot Switch connection for freezing and grabbing images
hands free.
Digital data output for personal computers equipped with
FireWire port.
Power connector. Use Gendex Concept IV FWT power
supply unit ONLY.
NOTE: The docking station is conceived for digital video streaming, therefore
it is intended for use with a computer system, through the FireWire
connection. The analog video output is featured for additional analog
monitor only, or for any analog recording or printing device capable of
S-Video input. The analog video output reproduces the video stream
coming from the handpiece only; it doesn't reproduce any video
coming from the auxiliary input. The docking station allows freezing
and saving images on the computer by pushing the supplied
footswitch. The docking station doesn't freeze or save images on or to
any analog device connected to the analog video output.
032-0161-EN Rev 5