Husqvarna AUTOMOWER 420 Operator's Manual page 29

charging station. Refer to
station on page 19 and To install the guide wire on
page 20 .
To change the signal range of the charging station
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 23 .
2. Use the arrow buttons and the OK button to move
through the menu structure
charging station > Overview of search methods >
Charging station range .
3. Use the left arrow button to select
4. Push the BACK button.
Note:
It is usually better to move the charging station,
than to decrease the range of the charging station
signal.
4.2.8.3 Corridor width
The boundary wire corridor is the area adjacent to
the boundary wire and the guide corridor is the area
adjacent to the guide wire. The product uses the
corridors to find the charging station. When the product
moves in the direction of the charging station, it always
moves to the left of the guide wire.
The corridor width is adjusted automatically. If it is
necessary to adjust the corridor width manually for the
product to operate satisfactorily, you can set the corridor
width between 0-9. If guide corridor width is set to 0, the
product straddles the guide wire. The factory setting is 6
for the boundary wire and 9 for the guide wire.
To set the corridor width
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 23 .
2. Use the arrow buttons and the OK button to move
through the menu structure
> Corridor width .
3. Use the arrow buttons to select a corridor.
4. Use the number buttons to select a corridor width
of 0-9.
1201 - 007 - 20.02.2023
To install the charging
Installation > Find the
MAX, MID, MIN .
Installation > Advanced
Note:
Make the corridor width as wide as possible for
a minimum risk of lines in the lawn.
4.2.8.4 Exit angle
Lawn Coverage function is less than
If the sum of the
100%, the product sometimes starts to mow at the
charging station. The product moves away from the
charging station with an exit angle between 90°–270°.
The exit angles can be set to 1–2 exit sectors.
To set the exit angle
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 23 .
2. Use the arrow buttons and the OK button to move
through the menu structure
> Exit angles > Sector 1 .
3. Use the number buttons to set the angles in
degrees.
4. Push the down arrow button.
5. Use the number buttons to select how frequently
the product must use each sector. Set in
percentage.
6. Push the BACK button.
4.2.8.5 Reversing distance
The reversing distance makes the product move in
reverse for a set distance, before the product starts to
cut the lawn.
To set the reversing distance
1. Do steps 1-3 in To get access to the menu in the
display of the product on page 23 .
2. Use the arrow button and the OK button to move
through the menu structure
> Reversing distance .
3. Use the number buttons to set the distance.
4. Push the BACK button.
4.2.8.6 Drive Past Wire function
The front of the product always moves past the
boundary wire by a specified distance. Then the product
moves rearward and changes direction. The factory
setting is 31 cm / 13 in. You can select a distance of
20-50 cm / 10-15 in.
Note:
If you change the distance for
the distance will change along the boundary wire in all
parts of the work area.
To set the Drive Past Wire function
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 23 .
2. Use the arrow button and the OK button to move
through the menu structure
> Drive Past Wire .
Installation > Advanced
Installation > Advanced
Drive Past Wire ,
Installation > Advanced
Product settings - 29