Table of Contents
Advertisement
Programming the module
Depending on the data system, program the module using these data system
screens:
•
In MassLynx, the Inlet Method Editor (see the MassLynx Help).
•
In Empower, the Instrument Method Editor dialog box (see the
Empower Help).
•
In Millennium
Control Module Instrument dialog box (see the Millennium
Maintenance and troubleshooting
Warning:
remove the module's protective panels behind which are no
user-replaceable components.
Cleaning the cabinet
Use a soft cloth dampened with water to clean the module's surface if it is
dirty.
Replacing the fuse
To replace the fuse
1.
Power-off the module, and then disconnect the power cord.
2.
Use a small screwdriver to remove the fuse holder from its socket in the
rear panel.
3.
Remove the faulty fuse from the fuse holder.
4.
Install a new, F 3.15-A fuse in the fuse holder (see
5.
Refit the fuse holder into its socket.
2-14
Installing the Pump Control Module II
32
Chromatography Manager 3.2 and 4.0, the Pump
To prevent injury to yourself or damage to the module, do not
32
Help).
Appendix
C).
Advertisement
Table of Contents
Troubleshooting
