Chapter 1 Introduction; Bus Sat/In Overview; Waters Bus Sat/In Module - Waters Bus SAT/IN Installation Manual

1 Introduction
This chapter is intended as an overview to the Bus SAT/IN module. Perform all Bus SAT/IN
module procedures in the order specified in this guide.
Attention: Do not power up this unit until all procedures described in this guide are
STOP
performed. Improper powerup can damage the unit and void the warranty.
Attention: The Bus SAT/IN module does not have an ON/OFF switch. Always disconnect
STOP
the power cord at either the wall outlet or the power supply before attaching or removing
the connection to the Bus SAT/IN module. Failure to do so may damage the unit.

1.1 Bus SAT/IN Overview

The Waters™ Bus SAT/IN™ (Satellite Interface) module is an A/D (analog-to-digital)
converter (Figure 1-1). The Bus SAT/IN module contains two individual A/D converters,
allowing conversion of two independent channels of data on two time bases.

Waters Bus SAT/IN Module

CHANNEL 1 CHANNEL 2
Figure 1-1 Waters Bus SAT/IN Module
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Waters
EVENTS
CH1
CH2
IN OUT IN OUT
+ -
+ -
CH CH OK
1 2
1 2 3 4 5 6 7 8
Bus SAT/IN Overview
1
13