Signal Conditions - Waters Pump Control Module II Installation Manual

HPLC system configuration using IEEE-488 communications
Module-to-pump cable

Signal conditions

Terminal strips for two event input (inject-start and stop-flow) and six event
output signal connections are located on the module's rear panel (see
"Terminal strips" on page
closures.
The event input signals the module to initiate a run or stop the flow using
event cables (see
trigger external devices when programmed in the pump events table (see
"Event-out connections" on page
The IEEE-488 communications interface on the module's rear panel provides
the means to manually set the IEEE-488 addresses via switch settings (see
"IEEE-488 signal cable connections" on page
IEEE-488
cable
Data control system
Pump Control
Module II
Pump
A
2-8). All external event connections are relay
"Event-in connection" on page
busLAC/E card
Event cables
Pump Pump
B C
2-10). The event outputs can
2-11).
2-5).
External event-in
(Inj or Stop Flow)
External event-out
(6 available)
Signal conditions 1-5