Table of Contents
Advertisement
8.1.1
Diagnostics: Status
Logbook/faults
Maintenance request
AUTOCAL deviation
O2 sensor status
8.1.1.1
Analyzer status: Status: Logbook/faults
Mains voltage
beyond tolerance
Press ENTER to clear
Next message with ->
End of messages
press ENTER to clear
next message with ->
ULTRAMAT 23
Equipment Manual, 04/2022, A5E37100388-012
In this menu you can call all status messages of the ULTRA‐
MAT 23 via further submenu items.
In this example, the status of the O
line. If the analyzer is equipped with an H
'Probe status' is shown in the last line with the following options:
• Only H
S sensor:
2
The analyzer calls this function directly.
• H
S and O
2
You will be requested to select the associated sensor.
This dialog displays the contents of a logbook. This contains
all recorded faults. Each type of fault only appears once in
the logbook and is output in plain text (an overview of the
possible faults can be found in section Faults (Page 180)).
Viewing the logbook is protected by code level 1.
Following access to the logbook you can:
• Delete the currently displayed fault using the <ENTER>
key. If further faults are present, these appear in succes‐
sion. You should delete all fault messages whose causes
have been eliminated.
• Display all recorded faults in succession using the <→>
key.
Note
By deleting the fault message you do not eliminate the cause
of the fault (see section Faults (Page 180)).
A corresponding text is output when all stored faults have
8111a
been displayed. Terminate display of the logbook using
the <→> key.
Note
If the analyzer is in measuring mode, you can recognize the
occurrence of a fault in that an "F" appears at the right edge.
A "! at the right edge signals that a fault has been logged
which is no longer present.
sensor is shown in the last
2
sensors:
2
Functions
8.1 Diagnostics
S sensor, the text
2
103
Advertisement
Table of Contents
