Analyzer Status: Diagnostics Values: Ir - Siemens ULTRAMAT 23 Series Equipment Manual

Functions
8.1 Diagnostics
Depending on your analyzer version, the starting menu may be different.
IR/UV diagn.
O2 diagnostic values
P and T values
Other diagn. values
IR Diagnostic values
UV Diagnostic values
IR diagnostic values
Sensor diagn. values
P and T values
Other diagn. values
8.1.2.1

Analyzer status: Diagnostics values: IR

IR diagnostic values
O2 diagnostic values
P and T values
Other diagn. values
Choose component
: NO2
Lockin-ADC + temp.
V-ADCt
Raw values
Lockin-ADC SO2
X= 408399 Y= 103444
R= 444912 V= 444872
B= 100116 T= 41.0°C
106
If the analyzer has an IR detector and a UV module, the adjacent
values
figure appears. After selection of the 'IR/UV diag. values' param‐
eter, the following prompt appears:
This prompt asks whether the diagnostic values apply to IR-ac‐
tive or UV-active components.
• IR diagnostic values: After the prompt, the menu switches to
812a
• UV diagnostic values: After the prompt, the menu switches to
If the analyzer has an H
The following versions are possible following selection of the
'Probe diagnostic values' parameter in the 2nd line:
• Only H
• H
This menu screen appears in the following cases:
• The analyzer has no UV module.
• In response to the prompt for whether the diagnostics ap‐
You must first identify the component to which the diagnostic
values are to apply.
2
After the <ENTER> key is pressed, the following selection menu
appears:
In this submenu you can call up the diagnostic values of the
selected infrared component. These are:
• ADU are voltage and signal values of the analog-to-digital
81211
section Analyzer status: Diagnostics values: IR (Page 106).
section Diagnostics: Diagnostic values: UV (Page 107).
S sensor, the adjacent figure appears.
2
S sensor: After selection of this item, the menu
2
switches to the diagnostic values of the H
(section Analyzer status: Diagnostics values: H2S sensor
(Page 109)).
S and O sensors: A query is made for the component, and
2 2
a switch then made to the called sensor.
plies to IR-active or UV-active components, IR-active compo‐
nents were selected.
converter prior to temperature compensation.
Equipment Manual, 04/2022, A5E37100388-012
S sensor
2
ULTRAMAT 23