Place The Specimen Slide; Adjusting The Condenser - Installing A Filter - Accu-Scope EXC-100 Series Manual

Table of Contents

ADJUSTMENT & OPERATION

Using Mechanical Stage

Fig. 15

Adjusting the Condenser – Installing a Filter

Fig. 16

Place the Specimen Slide

1. Push the lever① of the specimen holder backwards.

2. Place the slide on the stage with the cover glass② facing upwards.

Gently release the lever① and allow the clip to slowly close onto the

slide and clamp the slide firmly(see Fig.15).

★ Do not let go of the lever as the clamp will close too fast. This may

result in slide breakage and flying glass pieces.

3. Rotate the X and Y-axis knob③ of the stage, and move the specimen

to the center (aligned with the center of objective).

1. Before installing the filter, rotate the condenser to the bottom and

then open the filter holder.

★ Place the filter with the rough side downward.

73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com

EXC-100 MICROSCOPE SERIES

(continued)

Table of Contents