Observing A Specimen; Recharging The Microscope - Accu-Scope EXS-210 User Manual

ADJUSTMENT & OPERATION
①
Fig. 7
Fig. 8
®
ACCU-SCOPE
Observing a Specimen (Fig. 7)
Turn on the microscope.
Select the appropriate illuminator for the specimen being
observed; there are three modes of illumination:
Incident (top) – for viewing opaque specimens
Transmitted (bottom) – for viewing translucent specimens
②
Incident & Transmitted – to develop contrasting conditions on
a variety of specimens.
Place a specimen in the center of the stage plate area ①.
While looking through both eyepieces with both eyes, focus the
microscope at the highest power by turning the focus
adjustment knob(s) ② to bring the specimen into focus. This
will keep the specimen in close focus at any magnification. A
slight turn of the focusing knobs may be needed to sharpen
focus.
Recharging the Microscope (Fig. 8)
The LED cordless, rechargeable microscope is completely
portable and be used indoors or outdoors in any location where
there is no electrical outlet access.
The LED cordless microscope is powered by three 1.2v NiMH
AA 1300mAh (Nickel Metal Hydride) rechargeable batteries,
and when used properly can sustain approximately 2 hours
(depending on the light intensity/user) before a charge is
required.
Each microscope is supplied with its own 4.5v/1000A line
cord/charger and would require approximately 8 hours for a full
charge. The life expectancy of the rechargeable batteries is
approximately 10,000 hours or equivalent to 250 recharges
before needing replacement.
NOTE: Your microscope can be used while recharging.
Use ONLY the AC adapter/cord that came with your
microscope.
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
EXS-210 STEREO MICROSCOPE
(continued)
8