Table of Contents
Advertisement
Navigating through the menus
The menus are in the hierarchy as shown in the diagram above. Use the + and - keys to
move between menus in the same level ("vertically" in the table). The + key shows the
next menu, while the - key shows the previous one. Change levels by using the
keys. The
key moves to lower levels (sub-menus), while the
levels.
To make change to a specific item, for example, the sleep mode timeout time, proceed as
follows:
1
Press the MODE key.
The message display will show one of the first level menus (Level 1 in the table on
pages 35 and 36) depending on the previous selection.
2
Press + until Others > is shown on the display.
3
Press
.
The message display will show one of the second level menus (Level 2 in the table
on pages 35 and 36) belonging to the Others menu above depending on the
previous selection.
4
Press + until Sleep timer is shown on the display.
5
To change the timeout value, press ENTER.
If you want to abandon setting, press CANCEL, then press MODE.
6
Press + repeatedly to increase the timeout time; press - repeatedly
to decrease the timeout time until the desired timeout time (in
minutes) is displayed.
7
Press ENTER to confirm the new setting.
You can abandon the new setting by pressing CANCEL, then MODE.
8
To quit the mode selection sequence, press EXIT.
Using the Printer
key moves to higher
(2), (4), (6)
(3)
(5), (7)
(1), (8)
and
37
Advertisement
Table of Contents
