Table of Contents
Advertisement
Care and Maintenance
96
Error Message
I/F occupied
Imaging unit
not locked
Insert the same
MEMORY CARD
KPDL Error ##
Press CONTINUE
Left cover Open
Load paper
<paper size>
MEMORYCARD err##
Press CONTINUE
MEMORY CARD err
Insert again
Memory overflow
Press CONTINUE
Missing FK-80
Fuser KIT
Possible Cause
The front control panel
operation you attempted
is not possible because
that interface is receiving
data.
The imaging unit is not
locked properly because
its lever is not lifted.
A different memory card
was inserted following the
MEMORY CARD err/
Insert again message.
The printer encountered
an error during process-
ing data in KPDL mode.
The left side cover is open. Close it tightly.
The paper size does not
match.
The printer has encoun-
tered an error during
access to the memory
card.
The memory card was
removed during the
memory card operatin.
The print data from the
computer is larger than
the printer can fit in its
memory.
The fuser kit is not
installed in the printer.
Corrective Action
Wait until the data transfer is
completed on that interface.
Lift the imaging unit lever
fully up.
Reinsert the same memory
card as was removed previous-
ly into the printer's memory
card slot.
Note the error code of ## and
press CONTINUE to clear the
error situation. See section
KPDL Error Codes (
P. 100)
for information.
Put the media cassette loaded
with the paper of the correct
size as specified by the appli-
cation software into the
printer. To resume printing
using the current media
cassette, press CONTINUE.
(You must press CONTINUE
every time one sheet has been
printed, because the same
message will again be dis-
played from the second sheet
onward.) To abandon printing,
press CANCEL.
Look at the error code of ##
preceded by MEMORYCARD
err. Then, press CONTINUE to
clear the error situation. Refer
to section Memory card errors
(
P. 55).
Re-insert the same memory
card into the printer's memory
card slot. The printer will
continue with the memory
card operation.
Press CONTINUE to print the
data. Install additional memo-
ry or use a lower resolution
print quality (
P. 46).
Install the fuser kit.
Advertisement
Table of Contents
