Table of Contents
Advertisement
SYSTem . . . [:RECeive]:SBITs 1 | 1.5 | 2
SYSTem . . . [:RECeive]:SBITs?
SYSTem . . . :TERMinator:TRANsmit CR | LF | CRLF | NONE | <NRf>
SYSTem . . . :TERMinator:TRANsmit?
SYSTem:COMMunicate:SERial[1|2|3|4][:RECeive]:SBITs
bits to be used to transmit and receive data.
SYSTem:COMMunicate:SERial[1|2|3|4][:RECeive]:SBITs?
bit setting.
This command defines a termination character for the specified port's transmit
operations. The port to be affected by the command is specified by the port number
after the :SERial command (i.e. SERial1 is Port 1, SERial2 is Port 2, etc.). If a port
number is not specified, Port 1 is defaulted (that is :SERial is the same as :SERial1).
The termination character can be:
•
Carriage Return (CR)
•
Line Feed (LF)
•
Both Carriage Return and Line Feed (CRLF)
•
Termination character not sent (NONE)
•
Any ASCII character (specify the ASCII value -2 to 255, -2 is CRLF, -1 is
NONE)
If a terminator character is set, the driver sends the data after the terminator character
is received.
Power-on/reset default is LF.
This command returns the ASCII numeric equivalent of the current defined
termination character:
•
13 for Carriage Return (CR)
•
10 for Line Feed (LF)
•
-2 for both CR and LF
•
-1 for NONE
•
An ASCII integer value
sets the number of stop
returns the current stop
SCPI Command Reference
47
Advertisement
Table of Contents
