Table of Contents
Advertisement
Subsystem
Syntax
38 SCPI Command Reference
The SYSTEM command subsystem configures the RS-232 ports. The port to be
affected by the command is specified by the port number after the
(i.e.
:SERial1
is Port 1,
:SERial2
1 is defaulted (that is
:SERial
SYSTem
[:COMMunicate]
:SERial[1|2|3|4]
:CONTrol
:CTS 0 | 1 | OFF | ON
:CTS?
:DSR 0 | 1 | OFF | ON
:DSR?
:DTR ON | OFF | STANdard | IBFull
:DTR?
:RTS ON | OFF | STANdard | IBFull
:RTS?
:ERRormode IGNOre|STOP
:ERRormode?
:MODE NORMal | ECHO | LLOOP | RLOOP
:MODE?
[:RECeive]
:BAUD < baud_rate >
:BAUD?
:BITS 5 | 6 | 7 | 8
:BITS?
:BLOCKsize < blocksize >
:BLOCKsize?
:PACE
[:PROTocol] XON | NONE
[:PROTocol]?
:THReshold
:PARity
:CHECk 1 | 0 | ON | OFF
:CHECk?
[:TYPE] EVEN | ODD | ZERO | ONE | NONE
[:TYPE]?
:SBITs 1 | 1.5 | 2
:SBITs?
:TERMinator
:TRANsmit CR|LF|CRLF|NONE|NR1
:TRANsmit?
:RECeive CR|LF|CRLF|NONE|NR1
:RECeive?
:PASSthrough 1 | 0 | ON | OFF
:PASSthrough?
:TIMEout <time>
:TIMEout?
SYSTem Subsystem
is Port 2, etc.). If a port number is not specified, Port
is the same as
:SERial1
:STARt < characters >
:STARt?
:STOP < characters >
:STOP?
command
:SERial
).
Advertisement
Table of Contents
