Section 11 Security Menu; Access Rights Management - Hach ORBISPHERE K-M1100 User Manual

Section 11
Note: When the instrument is started for the first time, security is enabled. Refer to
page
rights as soon as possible to avoid any unauthorized access. Details of this process are described in this
section.

11.1 Access rights management

Each user has a unique ID and password. The ID and password are used by the software to:
•
•
Once the ID and password are entered, the user is allowed to perform actions according to the
"Access level" that has been attributed to his ID by the Manager. Refer to
page
Level
0
1
2
3
4
At startup all menus are locked and a valid ID and password combination is required to get
access beyond the standard measurement view. Refer to
Note: If the instrument security is enabled and the login credentials are not known, contact Hach Service
support with the recovery code to get the login credentials. The recovery code shows on the login window.
The supplied login credentials expire in one day. Make sure to change the login credential with known
values.
Security Menu
45. It is highly recommended that each user be entered into the system and given appropriate access
Allow or deny a user to perform specific actions.
To trace this action with his "ID" in a log file.
16.
Typical rights
View parameters, change views
+ Start / Stop measurements
+ Calibration
+ Modify parameters
+ Modify table "User  Access level"
+ Enable/Disable "Access right" features
Figure 42 Security menu
Table 3 Access levels
Press the unlock button and OK to access
There is at least one ID having the level 4
Section 5 Start up on page
Section 5 Start up on
Security level table on
Comments
45.
91