Section 4 Operation; Operating The Sc Controller; Sensor Setup; Sensor Data Logger - Hach ULTRATURB sc User Manual

Section 4

4.1 Operating the sc controller

4.2 Sensor setup

4.3 Sensor data logger

4.4 Menu structure

4.4.1 SENSOR DIAG

ERROR LIST
Possible error messages: WIPER POS, LED C., GAIN TOO HIGH
WARNING LIST
Possible warnings: PROFILE COUNTER, MOIST, USER CAL INTERVAL
Operation
The sensor can be operated with all sc controllers. Prior to using the sensor,
familiarise yourself with the principle of operation of your controller. Learn how to
navigate in the menus and run appropriate functions.
When you connect the sensor for the first time, the serial number of the sensor is
displayed as the sensor name. You can change the sensor name as follows:
1. Open the MAIN MENU.
2. Choose SENSOR SETUP and accept.
3. Choose the related sensor and accept.
4. Choose CONFIGURE and accept.
5. Choose EDITED NAME and accept.
6. Edit the name and accept to return to the SENSOR SETUP menu.
In the same way complete your system configuration using the following
commands:
• MEAS UNITS
• CLEAN. INTERVAL
• RESPONSE TIME
• LOGGER INTERVAL
• RESOLUTION
• SET DEFAULTS
A data memory and event memory per sensor are available via the sc controller.
While measured data are saved in the data memory at stipulated intervals, the
event memory collects numerous events such as configuration changes, alarms
and warning conditions. Both the data memory and the event memory can be
read out in CSV format. For information on how you can download the data,
please see the controller manual.
Note: In Section 7, page 29
warnings, also a description of all the actions necessary.
you will find, along with a list of all error messages and
15