E840-0000--
Detection Description
Remedy
E996-0071--
Detection Description
Remedy
Pressure release mechanism error
An error in the pressure release mechanism of the Fixing Assembly was detected.
1. Check the harness/connector between the Fixing Pressure Release Switch (SW2) and the
Engine Controller PCB (UN1).
2. Check the harness/connector between the Fixing Motor (M702) and the Engine Controller PCB
(UN1).
3. Replace the Fixing Motor (M702).
4. Replace the Fixing Assembly (including the Fixing Pressure Release Switch (SW2)).
5. Replace the Engine Controller PCB (UN1).
Error that can be retried
Retryable soft logic jam occurred.
1. Turn OFF and then ON the power.
2. Clear the COPIER > OPTION > FNC-SW/JM-ERR-R of Clear.
153
8. Error/Jam/Alarm