Canon imageCLASS X LBP1238 II Service Manual page 176

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > FEED-ADJ
ADJ-C1XR
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Additional Functions
Mode
ADJ-C2Y
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Additional Functions
Mode
Adjustment of write start position in horizontal scanning direction at Cassette 1 pickup (1st
side of 2-sided print)
To adjust the write start position in the horizontal scanning direction for the image on the 2nd side
at the time of pickup from the Cassette 1.
As the value is changed by 1, the left margin is changed by 0.001 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
The setting is applied to the 1st side at 2-sided print.
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key) and press Apply key.
This setting is linked with the setting of [Adjust Print Position] in [Settings/Registration].
The setting value is not cleared even if COPIER> FUNCTION> CLEAR> SRVC-DAT is executed.
-5080 to 5080
0.001 mm
0
COPIER > FUNCTION > CLEAR > SRVC-DAT
Adjustment/Maintenance > Adjust Image Quality > Adjust Print Position
Adjustment of write start position in feed direction at Cassette 2 pickup (1-sided print/2nd
side of 2-sided print)
To adjust the image write start position in the feed direction at the time of pickup from the Cassette
2.
As the value is changed by 1, the leading edge margin is changed by 0.001 mm.
+: Leading edge margin becomes larger. (An image moves to the trailing edge side.)
-: Leading edge margin becomes smaller. (An image moves to the leading edge side.)
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
The setting is applied to the 1st side at 1-sided print and the 2nd side at 2-sided print.
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by +/- key) and press Apply key.
This setting is linked with the setting of [Adjust Print Position] in [Settings/Registration].
The setting value is not cleared even if COPIER> FUNCTION> CLEAR> SRVC-DAT is executed.
-5080 to 5080
0.001 mm
0
COPIER > FUNCTION > CLEAR > SRVC-DAT
Adjustment/Maintenance > Adjust Image Quality > Adjust Print Position
166
9. Service Mode