Canon imageCLASS X LBP1238 II Service Manual page 75

The system manager can operate/set all the items in the [Settings/Registration] menu of the device.
However, if the security policy has been set by the security administrator described later, even the system manager cannot perform
operation or change the settings against the security policy.
The security administrator is an administrator who creates, applies, edits, backs up, and restores the security policy.
The security administrator is a system manager and is a user who knows the password for the security policy settings.
Account
Add/
delete
Security administrator
System manager
End user
Service technician
● Security Administrator Password
The security administrator password is a password that is set to protect the configured security policy. The password setting is
not mandatory.
Behavior when the security administrator password has been set
If the security administrator password has been set on this equipment, the security administrator password is required when
[Initialize All Data/Settings] is executed. This is intended to prevent the device from being initialized without discretion and
the configured security policy from being disabled.
NOTE:
Even if the security administrator password has not been set, as long as the security policy has been configured, [Management
Settings] > [Data Management] > [Initialize Menu] is grayed out and cannot be used.
Importing the security administrator password
If a security policy setting file of iR ADVANCE series where the security administrator password has been set is imported
via iW EMC DCM Plug-in, the security administrator password is not reflected.
In the case of importing the file via iW EMC DCM Plug-in, it is necessary to execute [Create Task to Change Security Policy
Password] and distribute the security administrator password to set the security administrator password.
Model of the same series
Initializing the security administrator password
In case the user has forgotten the security administrator password, there is a service mode setting for initializing the password.
Execute the service mode shown below to initialize the security administrator password set on this equipment.
Service mode > COPIER > Function > CLEAR > PLPW-CLR
*1. Restrained by the policy
[Settings/Registration] menu
Settings Settings
(Adminis- (Other
trator set- than the
tings) adminis-
trator set-
tings)
*1 *1
*1 *1
- -
*1
- -
Setting information and
the security administrator password
Export
DCM
Plug-in
Initialize Initialize Intro-
(User (Service duce/
mode) mode) change
-
- -
- -
-
Import
Data
DCM file
DCM
Setting information
Distribute the setting information
Administrator password DCM ファイル
Distribute the administrator password
65
3. Technical Explanation (System)
Policy-related
Browse Back up/
restore
-
- - -
- - -
This equipment
This equipment
Disable
the re-
strictions
-
-