Supermicro X13SAV-PS User Manual page 87

PCIe M.2-B OPROM
Use this feature to select which firmware type to be loaded for the add-on card in this slot.
The options are Disabled and EFI.
PCIe M.2-E OPROM
Use this feature to select which firmware type to be loaded for the add-on card in this slot.
The options are Disabled and EFI.
Onboard LAN1 Support
Use this feature to enable or disable LAN1. The options are Disabled and Enabled.
Onboard LAN1 Option ROM
Use this feature to select which firmware function to be loaded for LAN1 used for system
boot. The options are Disabled and EFI.
Wake On LAN
Select Enabled for wake on LAN support, which allows the system to wake up when an
onboard LAN device receives an incoming signal. The options are Disabled and Enabled.
SATA And RST Configuration

SATA Controller(s)
Use this feature to enable or disable the onboard SATA controller supported by the Intel PCH
chip. The options are Enabled and Disabled.
Storage Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Do not Launch and EFI.
Support Aggressive Link Power Management
When this feature is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods of
I/O inactivity and will return the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
I-SATA 0/I-SATA 1
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Software Preserve Support
Hot Plug
Set this feature to Enable for hot plug support, which allows you to replace a SATA drive
without shutting down the system. The options are Disabled and Enabled.
87
Chapter 4: UEFI BIOS