Jumpers and Connectors (Cont.)
LVDS/eDP panel voltage selection (JLVDS1/JLVDS2)
Function
Set LVDS Panel as +5V
(2-4)
Set LVDS Panel as +3.3V
(Default) (4-6)
Set LVDS Panel as +12V
(3-4)
CAUTION
The CD disc contains a driver installer program that will lead you through the installation as various device drivers are needed
to take full advantage of your motherboard.
Software Installation
The computer is supplied with a battery-powered real-time clock circuit. There is a danger of explosion if the battery is incor-
rectly replaced. Replace only wih same or equivalent type recommended by the manufaturer. Discard used batteries accord-
ing to manufaturer's instructions.
Board Diagram
4 AIMB-218 Startup Manual
Setting
JEIDA / VESA selection (JLVDS_VCON1)
Function
Pull high to +3.3V.
(JEIDA or VESA base on
panel definition)
Pull down to GND.
(Default)
(JEIDA or VESA base on
panel definition)
Setting
1
1