Table of Contents
Advertisement
USING CONNECTION MANAGER
10.
Click Install. Windows may prompt you to allow the installer to make changes to your computer. Click
Yes.
11.
In the Setup Wizard, click Finish.
Note:
To open Connection Manager automatically after installation, check Start the MultiTech Connection
Manager when the installation is finished.
If using a USB device, you can connect the device to the carrier's network with Connection Manager. Refer to
Connecting a
Device.
If using a serial device, you need to set up the device in Windows Device Manager before connecting the device.
Refer to
Setting Up a Serial Device in Windows Device
Setting Up a Serial Device in Windows Device Manager
To set up the device in Windows Device Manager:
1.
Make sure that your desired COM port for the serial device is available.
2.
Connect the serial device to the PC.
3.
Go to Control Panel > Device Manager. Make a note of the COM port number for the connected device
(in COM Ports).
Example: The COM port is COM31.
4.
Go to Action > Add legacy hardware.
5.
In the Add Hardware Wizard:
a.
Click Next.
36
Manager.
®
MultiConnect
Dragonfly
TM
MTQ-L1G2D Device Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiConnect Dragonfly MTQ-L1G2D and is the answer not in the manual?
Questions and answers