Table of Contents
Advertisement
Programming the Interface
Introduction
This chapter describes how to program your system for the desired interface.
Programming the Interface - Plug and Play
Plug and Play bar codes provide instant scan engine set up for commonly used interfaces.
Note: After you scan one of the codes, power cycle the host terminal to have the interface in effect.
RS232 Serial Port
The RS232 Interface bar code is used when connecting to the serial port of a PC or terminal. The following RS232 Inter-
face bar code also programs a carriage return (CR) and a line feed (LF) suffix, baud rate, and data format as indicated
below. It also changes the trigger mode to manual.
USB PC or Macintosh Keyboard
Scan one of the following codes to program the scan engine for USB PC Keyboard or USB Macintosh Keyboard. Scanning
these codes also adds a CR suffix. Default = USB Keyboard (PC).
*USB Keyboard (PC)
USB HID
Scan the following code to program the scan engine for USB HID bar code scanners.
Option
Setting
Baud Rate
115,200 bps
Data Format
8 data bits, no parity bit, 1 stop bit
TERMID0;232BAD9;232WRD2
RS-232 Interface
USB HID Bar Code Scanner
USB Keyboard (Mac)
2 - 1
Advertisement
Table of Contents
