Chapter 5 - Data Formatting; Data Format Editor Introduction; Add A Data Format - Honeywell Virtuos 1D User Manual

Data Formatting

Data Format Editor Introduction

You may use the Data Format Editor to change the scan engine's output. For example, you can use the Data Format Editor to
insert characters at certain points in bar code data as it is scanned. The selections in the following pages are used only if you
wish to alter the output. Default Data Format setting = None.
Normally, when you scan a bar code, it is output automatically. However, when you create a format, you must use a "send" com-
mand (see Send Commands
Multiple formats may be programmed into the scan engine. They are stacked in the order in which they are entered. However,
the following list presents the order in which formats are applied:
1. Specific Terminal ID, Actual Code ID, Actual Length
2. Specific Terminal ID, Actual Code ID, Universal Length
3. Specific Terminal ID, Universal Code ID, Actual Length
4. Specific Terminal ID, Universal Code ID, Universal Length
5. Universal Terminal ID, Actual Code ID, Actual Length
6. Universal Terminal ID, Actual Code ID, Universal Length
7. Universal Terminal ID, Universal Code ID, Actual Length
8. Universal Terminal ID, Universal Code ID, Universal Length
The maximum size of a data format configuration is 2000 bytes, which includes header information.
If a bar code is read that fails the first data format, the next data format, if there is one, will be used on the bar code data. If there
is no other data format, the raw data is output.
If you have changed data format settings, and wish to clear all formats and return to the factory defaults, scan the Default Data
Format code below.

Add a Data Format

Step 1. Scan the Enter Data Format symbol
Step 2. Select Primary/Alternate Format
Determine if this will be your primary data format, or one of 3 alternate formats. This allows you to save a total of 4
different data formats. To program your primary format, scan 0 using the
this manual. If you are programming an alternate format, scan 1, 2, or 3, depending on which alternate format you are
programming. (See "Primary/Alternate Data Formats" on page 5-10 for further information.)
Step 3. Terminal Type
Refer to Terminal ID Table
the inside back cover to program the scan engine for your terminal ID (you must enter 3 digits). For example, scan 0 0
3 for an AT wedge.
Note: 099 indicates all terminal types.
Step 4. Code I.D.
In the Symbology Charts,
the Hex value for that symbology and scan the 2 digit hex value from the
this manual.
If you are creating a data format for Batch Mode Quantity, use 35 for the Code I.D.
Note: 99 indicates all symbologies.
on page 5-3) within the format program to output data.
* Default Data Format
(page 5-2).
(page 5-3) and locate the Terminal ID number for your PC. Scan three numeric bar codes on
beginning on page A-1, find the symbology to which you want to apply the data format. Locate
Programming Chart inside the back cover of
Programming Chart inside the back cover of
5 - 1