Character Activation Timeout; Deactivation Character; Reread Delay - Honeywell Vuquest 3310g User Manual

Character Activation Timeout

You can set a timeout for the length of time the illumination remains on and attempting to decode bar codes when using
Character Activation Mode. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting
the timeout (from 1-300,000 milliseconds) by scanning digits from the
manual, then scanning Save. Default = 30,000 ms.

Deactivation Character

This sets the character used to terminate scanning when using Character Deactivation Mode. On the
Chart (Code Page 1252), page A-3, find the hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
ASCII character. Scan

Reread Delay

This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against
accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads. Use shorter delays in
applications where repetitive bar code scanning is required. Reread Delay only works when in a
3-6). Default = Medium.
Short (500 ms)
Long (1000 ms)
3 - 12
Character Activation Timeout
Programming Chart
Save to finish.
Deactivation Character
Programming Chart
to read the alphanumeric combination that represents that
inside the back cover of this
ASCII Conversion
Presentation Mode (see page
* Medium (750 ms)
Extra Long (2000 ms)