About The Literider Service Guide; Literider Components - Golden LiteRider GL140 Service Manual

Table of Contents

Advertisement

ABOUT THE LITERIDER™ SERVICE GUIDE
This service guide provides you with the information necessary to troubleshoot the Golden Technologies LiteRider
GL110/GL140. The troubleshooting scenarios in this manual consist of procedures that enable you to systematically trace
and correct faults in the system. Appendices A and B include instructions on how to measure voltage and continuity with
a multimeter. Appendix C includes a copy of figure 8 that may be printed separately. Appendix D contains flow charts of
the more complex troubleshooting procedures.
Before troubleshooting, check the following:
Make sure that the circuit breaker is reset.
Visually check terminals for corrosion. Check wires for missing insulation.
Make sure that the batteries are fully charged and are in good working order. When possible, keep sets of
known good batteries of various ratings in your shop at all times. The LiteRider uses two (2) 18AH
batteries. Problems that surface during troubleshooting are often due to the fact that the batteries are not
fully charged or can not hold their charge.
Make sure that the electrical connections are secure. Unplug the connectors and make sure all of the pins
are seated properly. Push the pins back into the connector housing if necessary. Make sure that the battery
terminals are tight.
NOTE: If you get to a point during troubleshooting where you cannot continue, call tech support at 800-624-6374.

LITERIDER COMPONENTS

The LiteRider is a battery-operated scooter with a controller that monitors the system and beeps when it detects a fault in
the system. The LiteRider was designed to operate within a range of between 18 – 24 volts (V) of direct current (DC).
The LiteRider control system is made up of the following components:
NOTE: The number after the component refers to the components position on figure 8 on page 9.
Circuit Breaker (1)
12V Batteries (2 and 3)
Battery Harness (4)
Power Harness (5)
Dynamics R-Series Controller (6)
Main Harness (7)
Front Intermediate Motor Harness (8)
Rear Intermediate Motor Harness (9)
Motor/Brake Assembly (10)
Brake (11)
Control Panel (12) includes Key Switch and Speed Control
Throttle Pot (13)
Charger Harness (14)
Off-Board Battery Charger – (not shown in illustration)
NOTE: Parts and service must be authorized by the Golden Technologies Service Department. Unauthorized
parts or service may void the warranty. For more information, contact the Golden Technologies Service
Department at 800-624-6374 or parts@goldentech.com.
LiteRider_SG_REVA_040711
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Literider gl110

Table of Contents