Control Panel; Brake - Golden LiteRider GL140 Service Manual

CONTROL PANEL REPLACEMENT
Tools needed: Phillips screwdriver and slotted screwdriver
1. Engage the park brake.
2. Remove the key from the key switch.
3. Remove the control panel shroud. See #1 on figure 33
on page 21.
4. Remove the four (4) screws that fastens the control
panel to the tiller. See #1 on figure 34 on page 21.
5. Disconnect the control panel from the main harness
and the throttle pot. See #1 and #2 on figure 35 on
page 21.
6. Connect the new control panel to the main harness
and the throttle pot.
7. Reinstall the new control panel onto the tiller.
8. Reinstall the control panel shroud.
BRAKE REPLACEMENT
Tools needed: 19mm Socket and Phillips screwdriver
1. Place the freewheel lever in the engaged position.
2. Remove the key from the key switch.
3. Remove the seat.
4. Remove the battery pack.
5. Loosen the right side drive wheel nut.
6. Separate the front and rear frames.
7. Remove the right drive wheels.
Make sure you retain the axle key.
8. Disconnect the brake from the motor harness.
9. Remove the four (4) screws that fasten the brake to
the motor. See #1 on figure 39.
10. Remove the brake.
11. Make sure that the new brake is in the disengaged position.
12. Fasten the new brake onto the motor with the four
screws removed in step 9.
13. Reinstall the right drive wheel.
14. Install the drivetrain onto the front frame.
15. Reinstall the battery pack.
LiteRider_SG_REVA_040711
1
Figure 37. Front Plastic Floor Mat
1
Figure 38. Tiller Cover Grommet
1
Figure 39. Brake Removal
22